Platinum Pet Fountain White 1 Count / 168 Oz by PetSafe

Product Description Developed by a Veterinarian, the Drinkwell Platinum Pet Fountain provides 168 oz (1.3 gal) of fresh, filtered water to your pet. A free-falling stream of water entices your pet to drink more and continually aerates the water with healthful oxygen. A charcoal filter removes bad tastes and odors, giving your pet the best way to stay hydrated. This fountain features many upgrades and a built-in reservoir to increase capacity and makes refills easy. Product Benefits Ingredients Suggestions Use Instructions: 1. Remove the lid and reservoir.2. Remove the pre-filter by pulling up on the top lip.3. Remove the housing by pushing in on both sides and lifting up.4. Remove the pump from the square indentation and pull the in-line plug up through the hole.5. Take the pump apart by first removing the faceplate. You may need to use a fingernail to pry it off.6. Remove the teardrop shaped stator by pulling up on the small lip.7. Use a fingernail to pull out the impeller, which is held in place magnetically.8. Rinse all fountain components (except for the adapter) with warm water before using the pet fountain. This will remove any residue from the manufacturing process.9. Reassemble the fountain.10. Rinse the carbon filter and insert it into the housing. It fits narrow side down, and the black side faces the front.11. Pick up the fountain by the bowl and place it in a desired location. Pour water into the bowl and the housing. Leave a ½ in. of space between the water level and the rim of the bowl.12. To fill the reservoir, turn it upside down and remove the cap. Fill it with water and replace the cap.13. Quickly turn the reservoir right side up and slide into place.14. Make sure the electrical power cord, the adapter and your hands are completely dry. Connect the in-line plug and make sure no silver is showing, then plug the adapter into a standard electrical wall outlet.Note: Never let the water level fall below 1 in. from the base of the bowl, or your pump might fail. Care and Cleaning Instructions: Replace the carbon filter every two to four weeks.1. Unplug the fountain and disconnect the in-line plug.2. Pick up the pet fountain by the bowl and take it to the sink.3. Disassemble the pet fountain and discard the carbon filter.4. You can use the motor brush from the Drinkwell Cleaning Kit to clean inside the pump. Use a solution of 80% water and 20% white vinegar to remove hard water buildup.5. Wash all other parts with warm water and soap or place in the top rack of the dishwasher. Note: Do not place the adaptor, rubber connector or pump in the dishwasher. Special Note Warnings DisclaimerPeta2z.com offers nationally branded products that are produced according to manufacturing standards set by regulators at everyday low prices. Do not use unproven, unbranded products, which can pose serious risks to your health.